Citrix Systems Network Cables 8200 User Manual Page 1

Citrix NetScaler 10.1 Quick StartGuide: MPX8005/8015/8200/8400/8600/8800PlatformCitrix NetScaler 10.1

wData bits: 8wParity: NonewStop bits: 1wFlow control: NoneLog on to the NetScaler with the following credentials:User name: nsrootPassword: nsrootTo c

2. NSIP address3.GatewayThe subnet mask, NSIP, and gateway values are saved in the configuration file. You canthen use the NSIP to connect to the appl

Note: The LEDs on the LOM port are unoperational by design on all MPX platforms,except MPX 22040/22060/22080/22100/22120.To Configure the NetScaler LO

System SpecificationsThe following table summarizes the specifications of the NetScaler MPX8005/8015/8200/8400/8600/8800 appliances.Specifications MPX

Additional InformationA complete set of NetScaler documentation is available on Citrix eDocs at http://support.citrix.com/proddocs/topic/netscaler/ns-

Copyright and Trademark NoticeCopyright © 2013 Citrix Systems, Inc. All rights reserved. NO PART OF THIS DOCUMENT MAY BE REPRODUCEDOR TRANSMITTED IN A

Quick Installation and ConfigurationWelcome to the Citrix NetScaler Application Delivery product line.Please review the following information before p

wSix 10/100/1000Base-T copper Ethernet ports and two 10G SFP+ ports(6x10/100/1000Base-T copper Ethernet ports + 2x10G SFP+)The following figure shows

Configuration RequirementsDetermine the following information for performing the initial configuration.wNetScaler IP address (NSIP): The management IP

Figure 1-4. Rack Mounting the ApplianceAppliance PrecautionswDetermine the placement of each component in the rack before you install the rail.wInstal

wThe handles on the left and right of the front panel of the appliance should be usedonly for extending the appliance out of the rack. Do not use thes

Figure 1-6. Connecting a Citrix NetScaler appliance to a power sourceNote: If you want to upgrade to the latest release of the system software beforep

Setting Up ConnectivityConnect the appliance to a management workstation or the network by using theNetScaler configuration utility, the command-line