Citrix Systems Network Router NETSCALER 9.3 User Manual download pdf (Page 66)

Parameters for configuring an SNMP view

name

Name of the SNMP view.

subtree

Subtree of the MIB.

type

Whether the subtree needs to be included or excluded.

To configure an SNMP view by using the configuration utility

1. In the navigation pane, expand System, expand SNMP, and then click Views.

2. In the details pane, click Add.

3. In the Create SNMP View or Configure SNMP View dialog box, specify values for

the following parameters, which correspond to parameters described in

"Parameters for configuring an SNMP view" as shown:

• Name*—name

• Subtree*—subtree

• Type—type

*A required parameter

4. Click Create or OK, and then click Close.

A message appears in the status bar, stating that the SNMP view has been

configured successfully.

Configuring a Group

SNMP groups are logical aggregations of SNMP users. They are used to implement access

control and to define the security levels. You can configure an SNMP group to set access

rights for users assigned to that group, thereby restricting the users to specific views.

You need to configure an SNMP group to set access rights for users assigned to that group.

To add an SNMP group by using the NetScaler command line

At a NetScaler command prompt, type the following commands to set the parameters

and verify the configuration:

w add snmp group <name> <securityLevel> -readViewName <string>

w show snmp group <name> <securityLevel>

Example

add snmp group edocs_group2 authPriv -readViewName

edocs_read_view

Done

> show snmp group edocs_group2 authPriv

Chapter 2 SNMP

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 194 195

No comments

Citrix Systems Network Router NETSCALER 9.3 User Manual Page 66