Citrix Systems Network Router NETSCALER 9.3 User Manual download pdf (Page 67)

1) Name: edocs_group2 SecurityLevel:

authPriv

ReadViewName: edocs_read_view

StorageType: volatile

Status: active

Done

Parameters for configuring an SNMP group

name

Name of the SNMP view.

securityLevel

The security level of the group. Possible values: noAuthNoPriv, authNoPriv, authPriv

readViewName

SNMP view to be associated with this group.

To configure an SNMP group by using the configuration utility

1. In the navigation pane, expand System, expand SNMP, and then click Groups.

2. In the details pane, click Add.

3. In the Create SNMP Group or Configure SNMP Group dialog box, specify values for

the following parameters, which correspond to parameters described in

"Parameters for configuring an SNMP group" as shown:

• Name*—name

• Security Level*—securityLevel

• Read View Name*—readViewName

*A required parameter

4. Click Create or OK, and then click Close.

A message appears in the status bar, stating that the SNMP group has been

configured successfully.

Configuring a User

SNMP users are the SNMP managers that the agents allow to access the MIBs. Each SNMP

user is assigned to an SNMP group.

You need to configure users at the agent and assign each user to a group.

To configure a user by using the NetScaler command line

At a NetScaler command prompt, type the following commands to set the parameters

and verify the configuration:

w add snmp user <name> -group <string> [-authType ( MD5 | SHA ) {-authPasswd } [-

privType ( DES | AES ) {-privPasswd }]]

Citrix NetScaler Administration Guide

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 194 195

No comments

Citrix Systems Network Router NETSCALER 9.3 User Manual Page 67