Citrix Systems Network Router NETSCALER 9.3 User Manual download pdf (Page 88)

You are prompted to enter the information for the following parameters:

NSIP: Specifies the IP address of the NetScaler appliance, for example, 10.102.29.1.

Userid: Specifies the user name, for example, nsroot.

Password: Specifies the password, for example, nsroot.

If you add multiple NetScaler IP addresses (NSIP), and later you do not want to log all

of the NetScaler appliance event details, you can delete the NSIPs manually by

removing the NSIP statement at the end of the auditlog.conf file. For a high

availability (HA) setup, you must add both primary and secondary NetScaler IP

addresses to auditlog.conf by using the audserver command. Before adding the IP

address, make sure the user name and password exist on the system.

Verifying the NSLOG Server Configuration File

Check the configuration file (audit log.conf ) for syntax correctness to enable

logging to start and function correctly.

To verify configuration, at a command prompt, type the following command:

audserver -verify -f <directorypath>\auditlog.conf

<directorypath>: Specifies the path to the configuration file (audit log.conf).

Running the NSLOG Server

To start audit server logging

Type the following command at a command prompt:

audserver -start -f <directorypath>\auditlog.conf

<directorypath>: Specifies the path to the configuration file (audit log.conf).

To stop audit server logging that starts as a

background process in FreeBSD or Linux

Type the following command:

audserver -stop

To stop audit server logging that starts as a service

in Windows

Type the following command:

Chapter 3 Audit Logging

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 194 195

No comments

Citrix Systems Network Router NETSCALER 9.3 User Manual Page 88